Post cap with special detail

A post cap is a decorative sleeve cast integral with the bottom of a bronze plaque to mount onto a round post. Post caps are available in several standard designs to accommodate 1-1/2" or 2" diameter post mounts.

Recommended uses

• Freestanding installation into the ground on a single post
• For plaques greater than 12" in width
• For double-faced plaques with copy on both sides

Curved Plaque

We can roll a bronze plaque to fit a curved wall installation. Provide the diameter, radius or circumference of the curved surface.

Parameters for usage

• Maximum size of plaque 96" wide x 60" high
• Flat backed castings, 1/4" or 3/8" thick
• Border design must be flat (Straight Edge, Single Line or Double Line)
• Mounting holes through the face are highly recommended.

The Garden stake is 24" long and has 2 holes matching the 2 holes we drill and tap in the back of your plaque.

The top can be straight or bent at a 30 degree angle (shown) for easier reading of you plaque.

Recommended uses for a SINGLE Garden Stake

• Mounting into ground
• For plaques 12" or less in width
• Maximum plaque size 12" x 8"

Recommended uses for a DOUBLE Garden Stake

• Mounting into ground
• For plaques over 12" in width and up to 20" in width
• Maximum plaque size 20" x 8"

Square Post Back Mount

This mount size depends upon the plaque size. It is used for post mounting of larger plaques or for the mounting of plaques at heights greater than provided by the garden stake.

Recommended uses

• Mounting into ground
• Maximum plaque size is unlimited since multiple posts can be utilized.